1003802 18 Pack OSI WINTeQ TeQ Seal Window Flange Sealant 10oz. White

Seal Sealant

• OSI WINTeQ TeQ Seal Elastomeric Window Installation Flange Sealant is a single component high quality sealant based on modified polyurethane polymers. This modified formula was designed for the WINTeQ? Window Installation System for easy application in all weather conditions. It offers fast cure when exposed to atmospheric humidity. TeQ Seal is permanently flexible, weather resistant and paintable
• It is compatible with all components in the WINTeQ Window Installation System. TeQ Seal goes on smoothly and has easy cut off without stringing. TeQ::Seal? adheres to wood, metal, vinyl, glass, aluminum and most common building substrates. This low VOC Formula meets State and Federal VOC regulations
• TeQ Seal is ideal for back caulking vinyl or aluminum window nailing flanges, for sealing between nailing flanges and weather resist barrier and exterior sheathing
• Ultra low VOC content - Qualifies for LEED points; Meets stringent State and Federal VOC regulations; Long lasting quality - Will not harden, crack, separate or yellow over time; Easy to Install - Can be installed in any weather condition; Will adhere to wet surfaces; Compatible with asphalt and butyl flexible flashing;
• Alcoholic odour; Modified Polyurethane Base; -40°F Service Temperature
• Not recommended for - Not intended to replace mechanical fasteners for attaching windows, Underwater applications or permanent water immersion and Applications requiring temperature resistance greater than 176°F
• Application - The joint width must be designed to suit the movement capability of the sealant. In general, the joint width must be greater than 10 mm (0.39?) and less than 35 mm (1.37?). A joint width to depth ratio of approximately 1:0.5 must be maintained. Using a caulking gun, extrude sealant forcing into joint. To ensure proper adhesion, immediately tool the sealant. Wipe nozzle tip and recap cartridge immediately after use.
• The temperature of the product, the surfaces and the working area must be above 40°F (5°C). For best performance, apply sealant at 70°F (21°C). Ensure surfaces to be sealed are clean, dry, structurally sound and free of dust, grease, oil, and other foreign contaminants. Cut off tip of cartridge above screw threads. Screw on nozzle, remove the cap and cut the tip off the cartridge nozzle just above the threads to desired bead size (3/8? recommended).
• For best performance, protect product from excessive heat or cold. For maximum shelf life store at 75°F (24°C). Take unwanted product to an approved household hazardous waste transfer facility. Hardened material may be disposed of with trash . California residents Click here for Proposition 65 warning

Technical Details